Table of Contents
Advertisement
TURNING LANESENSE ON OR OFF
The LaneSense button is located on the
switch panel below the Uconnect display.
To turn the LaneSense system on, push the
LaneSense button (LED turns off). A "Lane-
Sense On" message is shown in the instrument cluster
display.
To turn the LaneSense system off, push the LaneSense
button again (LED turns on).
NOTE:
The LaneSense system will retain the last system state
on or off from the last ignition cycle when the ignition is
changed to the ON/RUN position.
LANESENSE WARNING MESSAGE
The LaneSense system will indicate the current lane
drift condition through the instrument cluster display.
When the LaneSense system is on, the lane lines are
gray when both of the lane boundaries have not been
detected and the LaneSense telltale
System ON (Gray Lines) With White Telltale
Left Lane Departure — Only Left Lane Detected
•
When the LaneSense system is on, the LaneSense
Telltale
is solid white only when the left lane
marking has been detected and the system is ready
to provide visual warnings in the instrument cluster
display if an unintentional lane departure occurs on
the left side.
•
When the LaneSense system senses the lane has
been approached and is in a lane departure situa-
tion, the visual warning in the instrument cluster
display will show the left inside lane line flashing
yellow (on/off), while the outside lane line on the
left of the display will remain solid yellow. The Lane-
Sense telltale
flashing yellow.
is solid white.
Lane Approached With Flashing Yellow Line/Flashing
NOTE:
The LaneSense system operates with similar behavior
for a right lane departure when only the right lane
marking has been detected.
changes from solid white to
Yellow Telltale
STARTING AND OPERATING
Left Lane Departure — Both Lane Lines Detected
•
When the LaneSense system is on, the lane lines
turn from gray to white. The LaneSense telltale
is solid green when both lane markings have been
detected and the system is ready to provide visual
warnings in the instrument cluster display and a
torque warning in the steering wheel if an uninten-
tional lane departure occurs.
Lanes Sensed (White Lines) With Green Telltale
•
When the LaneSense system senses a lane drift
situation, the left inside and outside lane lines turn
solid yellow. The LaneSense telltale
from solid green to solid yellow. At this time torque is
applied to the steering wheel in the opposite direc-
tion of the lane boundary.
For example: If approaching the left side of the lane
the steering wheel will turn to the right.
153
4
changes
Advertisement
Table of Contents
