Table of Contents
Advertisement
Manual Rear Door Lock
1 — Door Handle
2 — Manual Door Lock
If the door lock is in the locked position (no ribbing is
visible) when you shut the door, the door will lock.
Therefore, make sure the key fob is not inside the
vehicle before closing the door.
NOTE:
The manual door locks will not lock or unlock the
liftgate.
WARNING!
•
For personal security and safety in the event of a
collision, lock the vehicle doors before you drive as
well as when you park and leave the vehicle.
•
Never use the PARK position as a substitute for the
parking brake. Always apply the parking brake fully
when parked to guard against vehicle movement
and possible injury or damage.
•
When exiting the vehicle, always make sure the
ignition is in the OFF position, remove the key fob
from the vehicle and lock the vehicle.
•
Never leave children alone in a vehicle, or with
access to an unlocked vehicle. Allowing children to
be in a vehicle unattended is dangerous for a num-
ber of reasons. A child or others could be seriously
or fatally injured. Children should be warned not to
touch the parking brake, brake pedal or the gear
selector.
•
Do not leave the key fob in or near the vehicle, or
in a location accessible to children, and do not
leave the Keyless Enter 'n Go™ Ignition in the ACC
or ON/RUN position. A child could operate power
windows, other controls, or move the vehicle.
POWER DOOR LOCKS —
IF EQUIPPED
A power door lock switch is on each front door trim
panel. Use this switch to lock or unlock the doors.
(Continued)
Driver Power Door Lock Switches
WARNING!
GETTING TO KNOW YOUR VEHICLE
If you push the power door lock switch while the ignition
is in the ACC or ON/RUN position, and any front door is
open, the power locks will not operate. This prevents
you from accidentally locking your key fob in the vehicle.
Placing the ignition in the OFF position or closing the
door will allow the locks to operate. A chime will sound
if the ignition is in the ACC or ON/RUN position and a
door is open, as a reminder to place the ignition in the
OFF position and remove the key fob.
KEYLESS ENTER 'N GO™ —
PASSIVE ENTRY
The Passive Entry system is an enhancement to the
vehicle's Remote Keyless Entry system. This feature
allows you to lock and unlock the vehicle's door(s) with-
out having to push the key fob lock or unlock buttons.
NOTE:
•
Passive Entry may be programmed on/off through
the Uconnect system
page 169.
•
The key fob may not be detected by the Passive
Entry system if it is located next to a mobile phone,
laptop, or other electronic device; these devices may
block the key fob's wireless signal and prevent the
Passive Entry handle from locking/unlocking the
vehicle.
•
If set by the customer in the Uconnect Settings,
unlocking with Passive Entry will initiate illuminated
approach (low beams, license plate light, parking
lights) for the duration of 0, 30, 60 or 90 seconds.
Passive Entry also initiates two flashes of the turn
signals.
31
2
Advertisement
Table of Contents
