Table of Contents
Advertisement
84
GETTING TO KNOW YOUR VEHICLE
•
If the phone moves on the pad causing the red light
to illuminate, the phone will have to be picked up
and placed back on the charging pad to resume
charging.
•
Wireless charging is not as fast as when the phone
is connected to a wired charger.
•
The phone's protective case must be removed when
placed on the wireless charging pad.
•
iPhone® 12 (including iPod®) is equipped with soft-
ware to protect the device from overheating. When
the software is active, the rate of charge is slowed
down to protect the device.
•
Phones must always be placed on the wireless
charging pad within the outline shown on the pad so
that its charging parts connect with the charging
coils of the system. Movement of the phone during
charging may prevent or slow the rate of charge.
•
Having multiple applications open on the phone
while charging will reduce the charging efficiency,
and may even shut down an application that is
actively running (i.e. Apple CarPlay®). This may also
cause the phone to overheat.
•
Wireless chargers may implement certain methods
to prevent the phone from overheating during charg-
ing such as slowing down the rate of charge. In cer-
tain instances, the device may shut down for a brief
period of time (when the device reaches a certain
temperature). If this happens, it does not mean
there is a fault with the wireless charging pad. This
may just be a protective measure to prevent dam-
age to the phone.
•
The use of multiple wireless functions at the same
time (wireless charging, Apple CarPlay®, Android
Auto™) could cause the device to overheat, resulting
in limitation of the functions or it turning off. In this
case, it is recommended to connect the system
using the USB port.
•
Do not place the key fob or any other type of metal/
magnetized object inside the mobile phone housing
or near the wireless charging pad.
•
With a compatible device placed on the charging
pad, and the ignition is cycled to the OFF position, a
reminder message may appear on the instrument
cluster display to warn the driver.
CAUTION!
The key fob should not be placed on the charging pad
or within 6 inches (15 cm) of it. Doing so can cause
excessive heat buildup and damage to the fob. Plac-
ing the fob in close proximity of the charging pad
blocks the fob from being detected by the vehicle and
prevents the vehicle from starting.
WINDOWS
POWER WINDOWS
The window switches on the driver's door trim panel
control all of the door windows.
Driver's Power Window Controls
The driver may lock out the rear power windows by push-
ing the bar control just below the power window controls.
Window Lockout Switch
The window switches will operate only when the ignition
is in the ACC or ON/RUN position and during power
accessory delay.
NOTE:
Power Window controls will also remain active for up to
10 minutes after the ignition has been placed in the
OFF position, depending upon the accessory delay set-
ting. Opening a front door will cancel this feature.
There is a single control on the front passenger's door
trim panel which operates the passenger door window
and a set of controls that lock and unlock all doors. The
controls will operate only when the ignition is in the ACC
or ON/RUN position and during power accessory delay.
Sliding Side Door Power Window Control — If Equipped
Second row passengers may open and close the sliding
door window by a single control on the door handle
assembly.
The controls will operate only when the ignition switch
is in the ACC or ON/RUN position and during power
accessory delay.
Advertisement
Table of Contents
