Edit Patient Information In A Patient Report - GE MAC VU360 Operator's Manual

• Press the Stop key on the keyboard:
• Press the Stop button on the Acquisition Module:

Edit Patient Information in a Patient Report

Make sure that you have the privilege to edit patient reports.
After a test is acquired, you can edit patient information using the keyboard or by
attaching an order. When an order is attached to a patient test, some fields are read-
only.
If you try to edit or attach an order to a patient report that is transmitted to the
default destination, an error message displays.
You cannot edit patient information by scanning a patient barcode, selecting a
patient record from the Patients list, or performing ADT queries.
WARNING:
INACCURATE PATIENT DATA - Incorrect patient information can cause patient
data mismatch. Data assigned to the wrong patient causes erroneous patient
data that can affect diagnosis and treatment.
Be sure to check the patient information screen for each new patient. Make
sure that you enter patient data for the correct patient.
1. To edit patient information for the patient report, select the Edit icon in the ECG
tab or the Rhythm or FD Report tab in the Acquisition screen:
The Patient Information screen opens.
2. Edit the patient information using a keyboard. See
Information Using the Keyboard on page
3. Select Save to save your changes for this patient and collapse the screen.
If you select any other icons at the bottom of the tab prior to saving, the Patient
Information screen collapses and the edited patient information is saved.
2088531-370-2 MAC VU360 ™ Resting ECG Analysis System
Enter or Edit Patient
39.
Recording an ECG or Rhythm
65