Put The Device On Standby; Perform System Reset - GE MAC VU360 Operator's Manual

Put the Device on Standby

Perform one of the following steps to put the device on standby:
• From the User Menu on the Acquisition screen, select Standby.
• Press the Power button on the keyboard:
• If a remote application session is not open, the device is put on standby.
• If a remote application session is open in the foreground or background and
Select Continue to put the device on standby.
To exit standby mode, press the Power button on the keyboard:
• If user authentication is configured, standby mode is off and the lock screen
• If user authentication is not configured, you are returned to the last screen

Perform System Reset

Before you begin this procedure, make sure that:
• You have the serial number of the device.
• The device is connected to AC power.
• If the authentication mode of the device is No authentication, access the Settings
screen from the user menu to open the Login screen.
• If the authentication mode of the device is Full Authentication with Stat, power
on the device to view the Login screen.
NOTE:
The System Reset deletes all data and settings. The system is reset to factory
defaults. Use the default admin password to log on to the device. It keeps
the previously enabled option codes, serial number, keyboard language, MAC
address, and Wireless Country of Operation configuration.
2088531-370-2
The Power Options dialog opens. Select Standby.
you select Standby, a message displays indicating that the standby mode will
close remote sessions and any unsaved data will be lost.
displays. Perform the procedure
and log in to the device.
displayed when the device was put on standby mode.
MAC VU360
Unlock the Device on page 26
™ Resting ECG Analysis System
Login and Security
to unlock
27