Table of Contents
Advertisement
Noise emission
The device generates a maximum sound power level of <80 dB(A) (ref. 1pW)
values
when idling and in the cooling phase following operation at the maximum per-
missible operating point under maximum rated load conditions according to EN
60974-1.
It is not possible to provide a workplace-related emission value during welding
(or cutting) as this is influenced by both the process and the environment. All
manner of different welding parameters come into play, including the welding
process (MIG/MAG, TIG welding), the type of power selected (DC or AC), the
power range, the type of weld metal, the resonance characteristics of the work-
piece, the workplace environment, etc.
Danger from tox-
The fumes produced during welding contain harmful gases and vapours.
ic gases and va-
Welding fumes contain substances that cause cancer, as stated in Monograph
pours
118 of the International Agency for Research on Cancer.
Use at-source extraction and a room extraction system.
If necessary, use a welding torch with an integrated extraction device.
Keep your face away from welding fumes and gases.
Fumes and hazardous gases
-
-
Ensure an adequate supply of fresh air. Ensure that there is a ventilation rate of
at least 20 m³ per hour at all times.
Otherwise, a welding helmet with an air supply must be worn.
If there is any doubt about whether the extraction capacity is sufficient, the
measured toxic emission values should be compared with the permissible limit
values.
The following components are responsible, amongst other things, for the degree
of toxicity of welding fumes:
-
-
-
-
-
The relevant material safety data sheets and manufacturer's specifications for
the listed components should therefore be studied carefully.
Recommendations for trade fair scenarios, risk management measures and for
identifying working conditions can be found on the European Welding Associ-
ation website under Health & Safety (https://european-welding.org).
Flammable vapours (e.g. solvent fumes) should be kept away from the arc's radi-
ation area.
Close the shielding gas cylinder valve or main gas supply if no welding is taking
place.
Danger from fly-
Flying sparks may cause fires or explosions.
ing sparks
8
must not be breathed in
must be extracted from the working area using appropriate methods.
Metals used for the workpiece
Electrodes
Coatings
Cleaners, degreasers, etc.
Welding process used
Advertisement
Table of Contents
