Basic Flushing - WAGNER EvoMotion 20-30 Original Operating Manual

Operating manual Piston Pump EvoMotion 20-30
7 Operation
Process for relieving pressure
10
1. Close the spray gun.
2. Close ball valve (2).
3. Release the system of pressure by opening the spray gun.
ð Attention: If a blocked nozzle is preventing relief, first carry out the additional steps
4 and 5, then clean the nozzle.
4. Close and secure the spray gun.
5. Open and close the return valve (3) slowly to completely depressurize the system.
Pressure relief of the air (in case of longer work interruptions)
1. Carry out pressure relief of the product (as mentioned above).
2. Ensure that the ball valve (2) is closed.
3. Pull the ring on the safety valve (10) and hold it until the pressure in the air motor has
been equalized.
NOTICE
Hardened working product in the spraying system when 2K product is processed!
Using 2K materials can destroy the pump and spraying system.
4 Observe the manufacturer's processing rules, particularly in regards to the pot life.
4 Flush thoroughly before the end of the pot life.
4 The pot life is decreased by warmth.
7.5 BASIC FLUSHING
Regular flushing
– Regular flushing, cleaning and maintenance ensures the pump's high conveying and
suction capacity.
– The cleaning and flushing agents used must be compatible with the working material.
– Do not flush hardener pumps with water. Only flush them using suitable flushing agents
(solvents).
Order number 2333553 | Edition 09/2020
B_06894
2
35