17.6
Ignition curve plug-in connector
17.7
Changing the ignition curve
Change the ignition curve from Performance to Soft.
–
Disconnect plug-in connector
Soft – better rideability
Change the ignition curve from Soft to Performance.
–
Join plug-in connector
Performance – better performance
17.8
Checking the basic position of the shift lever
Info
When driving, the shift lever must not touch the rider's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
17.9
Adjusting the basic position of the shift lever
Plug-in connector
located on the frame under the fuel tank.
Possible states
Soft – The plug-in connector of the ignition timing map
•
adjustment is disconnected to achieve better rideability.
Performance – The plug-in connector of the ignition timing
•
map adjustment is joined to achieve higher performance.
E00374-10
1
of the ignition timing map adjustment. (Figure E00374-10
1
of the ignition timing map adjustment. (Figure E00374-10
–
Sit on the vehicle in the riding position and determine
distance
lever.
Distance between shift
lever and upper edge of
boot
»
If the distance does not meet specifications:
–
Adjust the basic position of the shift lever.
400692-10
(
–
Remove screw
2
lever
401950-12
17 TUNING THE ENGINE
1
of the ignition timing map adjustment is
A
between the upper edge of your boot and the shift
10 ... 20 mm (0.39 ...
0.79 in)
p. 123)
1
with the washers and take off shift
.
p. 123)
p. 123)
123