Installing The Battery (150 Xc-Wus); Recharging The Battery (150 Xc-W Us) - KTM 150 XC-W 2018 Owner's Manual

15.2 Installing the battery
15.3 Recharging the battery
Warning
Environmental hazard Batteries contain environmentally-hazardous materials.
–
Do not dispose of batteries as household waste.
–
Dispose of batteries at a collection point for used batteries.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Info
Even when there is no load on the battery, it discharges steadily.
The charging level and the method of charging are very important for the service life of the battery.
Rapid recharging with a high charging current shortens the service life of the battery.
If the battery is depleted by repeated starting, the battery must be charged immediately.
(150 XC‑W US)
Main work
–
Insert the battery into the battery compartment with the termi-
nals facing forward and secure with holding bracket
Battery (HJTZ5S-FP) (
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
–
Connect positive cable
Guideline
Screw, battery termi-
nal
–
Slide positive terminal cover
–
Connect negative cable
Guideline
Screw, battery termi-
H00386-10
nal
Contact disks
cable sockets
nal.
Finishing work
–
Mount the seat. (
(150 XC‑W US)
Preparatory work
–
Press and hold the kill switch
the engine stops.
–
Remove the seat. (
–
Remove the battery.
15 ELECTRICAL SYSTEM
p. 147)
2 .
M6 10 Nm (7.4 lbf ft)
3
to the battery.
M5 2.5 Nm
(1.84 lbf ft)
7
over the positive terminal.
4
to the battery.
M5 2.5 Nm
(1.84 lbf ft)
A
must be mounted under screws
6
with the claws toward the battery termi-
p. 68)
while the engine is idling until
p. 67)
( p. 104)
1
.
5
and
105