Using Intercom Functionality - Mitel 6915 User Manual

Making Calls
3. If you have a DHSG/EHS headset with an RJ45 6-pin or 8-pin connector, remove the plastic headset
jack adapter and then insert the cord into the jack until it clicks into place.
Note:
See the Mitel 6915 IP Phone Installation Guide for more information.
4.
Press the
selected from the Options List, a dial tone or an incoming call is received on either the headset or the
handsfree speakerphone.
5.
Press the
Note:
You can answer, initiate and transfer a call by pressing the hook switch button on the DHSG
headset.
8.5

Using Intercom Functionality

On the 6915 you can use the Icom key to automatically connect with a remote extension.
Using the Icom Key
1. Press the Icom softkey.
2. If no number was defined when configuring the key, enter the extension number of the person you want
to intercom.
3. After a beep tone, your phone automatically connects with the remote extension and you can speak
through its speaker.
4.
To cancel the intercom, press
5. When you are finished speaking, hang up the phone by placing the handset back on-hook or by
pressing
up.
You can set specific incoming Intercom call features on the 6915 IP phone using the Mitel Web UI. The
following table describes these features.
113
key to obtain a dial tone or to answer an incoming call. Depending on the audio mode
key to end the call.
or the Cancel key.
or the line softkey for the active call. When you hang up, the remote phone also hangs
Version 1.0
User Guide