Mitel 6915 User Manual page 110

2. Select from Key 1 through Key 20 on the Top keys.
or
Select from Key 1 through Key 18 on the Bottom keys.
3. In the Type field, select Paging.
4. In the Label field, enter a label to apply to this key.
5. In the Value field, enter a multicast IP address and a port number for the Paging key. When you press
this key, the phone initiates an outgoing multicast RTP session to the specified address using the
specified port (e.g. 239.0.1.15:10000).
Note:
a. When you select Paging for the Type field, the Line field is disabled.
b. The Value field allows for one multicast address entry only.
6. To receive RTP steams for group paging, you must also configure the Paging Listen Addresses
parameter at the path, Basic Settings > Preferences > Group Paging RTP Settings.
7. Click Save Settings to save your changes.
Using the Paging Key
The following procedure describes the use of the Paging key on the IP phone. The procedure assumes
you have already configured the Paging key using the Mitel Web UI.
Note:
1. The recipient of a paging call can set a global DND to ignore any incoming pages.
2. For incoming paging, the phone uses the Intercom configuration settings. The incoming page is
dependent on the Allow Barge In parameter setting and the idling/on call state.
1. On the IP phone, press the softkey you configured for Paging. The phone opens a multicast RTP
session and an outgoing OR incoming phone screen displays.
2. Press the Drop key to end the multicast RTP session and return to the Home screen.
Note:
If you enable global DND on the phone, the incoming multicast RTP session is dropped.
Version 1.0
User Guide
Configuring Softkeys
104