Table of Contents
Advertisement
VMT6008
Note:
Since the timing of the integrated controller is specifically set up for cherry
keyboards, keyboards of this manufacturer should preferably be used.
If the soft keyboard is actively displayed on the monitor, the use of the external
keyboard for control purposes is limited.
The keyboard must be connected before switching the device on, because
the keyboard interface is initialised in the process of booting. If the keyboard
is plugged in while the device is running without having had the keyboard
connected while booting, it will not be functional.
Pos : 31 /D atentec hni k/Schnitts tell en/Netz werkansc hlus s RJ 45/Netz wer kansc hluss RJ 45 für VMT 60xx @ 2 \mod_1260451135970_6. doc @ 6856 @
6.7 Netzwork Connection (RJ45)
If the drivers required for functioning are installed on the device, the control system may be integrated in
an Ethernet network supporting the 10/100/1000Mbit standard by using the Ethernet 10/100/1000BaseT
network connector. Specifications of this network topology must be observed in this case. You can
install the drivers required for functioning from the enclosed service CD, should they not be installed on
the device.
Pin-Number
1
2
3
4
5
6
7
8
Note:
The device has two separately integrated network controllers of the Realtek
RTL 8111c Family PCIe Gigabit Ethernet type.
Note:
PXE booting is only possible by using the LAN1 port.
Pos : 32 /D atentec hni k/Schnitts tell en/Funknetz wer kkar te/Funknetz wer kkarte für VMT 6000 Serie @ 2\mod_1260517076470_6.doc @ 6872 @
© ads-tec GmbH • Heinrich-Hertz-Str.1• 72622 Nürtingen
Signal-Name
TX +
TX -
RX +
NC
NC
RX -
NC
NC
27
Advertisement
Table of Contents
