ADS-tec VMT6000 Series User Manual page 9

Hide thumbs Also See for VMT6000 Series:

Table of Contents

VMT6008

2.2 Damage Caused By Improper Use

This device must immediately be shut down and protected from any accidental commissioning if the

operating system shows any obvious damage caused by, for example, improper operating or storage

conditions, or by improper use or handling.

2.3 Warranty / Repair

During the warranty period, any repair must only be carried out by the manufacturer or by a person

authorised by the manufacturer.

2.4 Treatment and Disposal of Lithium Batteries

This device contains a lithium battery for supplying the system clock with power as long as the supply

voltage is not connected. The battery has a life cycle of 3 - 5 years depending on which load is applied.

Note:

The more the battery is exposed to higher temperatures, the faster it ages.

Warning:

There is an acute risk of explosion should the wrong type of battery be used.

Warning:

Do not put lithium batteries into a fire, do not solder on the cell body, do not

recharge them, open them, short-circuit them, do not reverse their polarity or heat

them up over 100°C; dispose of them properly and protect lithium batteries from

direct sun light, humidity and condensation.

Lithium batteries may only be replaced by the same type, or by a type recommended by the

manufacturer.

The lithium battery must be disposed of according to the local legislation at the end of its life cycle.

2.5 Notes on Safety

Warning:

Installation works at the device are only permitted if the device is disconnected

from the power supply and protected from accidental switch-on.

Note:

Always adhere to the safety measures applicable when handling components at

risk of being destructed by electrostatic discharges..

(DIN EN 61340-5-1 / DIN EN 61340-5-2)

Table of Contents

Vmt6008