ADS-tec VMT6000 Series User Manual page 8

VMT6008
2 Notes on Operation & Safety
This device contains electrical voltages and extremely sensitive components. Intervention by the user is
only designated for establishing the required cable connections. The manufacturer or a service partner
authorised by the manufacturer should be consulted if you plan to make further modifications. Before
beginning any works on this device, it must be disconnected from the power supply. Suitable measures
for avoiding any electrostatic discharges towards components must be taken. If the device is opened by
an unauthorised person, hazards for the user might arise and any warranty claim will cease.
General Instructions

All users must read this manual and have access to it at all times

Installation, commissioning and operation may only be carried out by trained
and qualified staff

The security instructions and the manual itself must be observed by all
persons who work with this device

At the location of use, the valid guidelines and regulations for accident
prevention must be observed

The manual contains the most important instructions on how to use this device
in a safe way

Appropriate storage, proper transport, installation and commissioning, as well
as careful operation are prerequisites for ensuring safe and proper operation
of this device

The device can be cleaned by using a soft cloth and a commercially available
glass cleaning agent (e.g. Sidolin) with low alcohol content.
Warning:
Any installation works on the device are only permitted if the power supply is
switched off, and handling the device is safe.
2.1 Operation Location
The VMT control system is designed for use on support arm systems or on moving transport equipment
(like commissioning trolleys, forklifts or similar). You have to take care that the environmental conditions
specified in the technical data specification are met. Using the device in non-specified environments, for
example on board ships, or in areas that might contain explosive gases or in extreme heights is
prohibited.
Warning:
For the prevention of water condensate accumulation, the unit should be turned
ON only when it reaches ambient temperature. This particularly applies when the
unit is subject to extreme temperature fluctuations and/or variations.
Avoid overheating during unit operations; the unit must not be exposed to direct
sunlight or any other direct light or heat sources.
© ads-tec GmbH • Heinrich-Hertz-Str.1• 72622 Nürtingen
7