Table of Contents
Advertisement
VMT6008
6 Interfaces
6.1 Interface Setup
Interface
COM1
RFID (Touch)
Pos : 26 /D atentec hni k/Schnitts tell en/Spannungs versorgung/Spannungs versorg ung für VMT60xx- Seri e @ 2\mod_1260450284020_6.doc @ 6853 @
6.2 24V DC Power Supply
The supply voltage is provided via a lead-through terminal including a screw connection (Phoenix
Contact COMBICON MC 1,5/4-STF3.81). (The figure shows the socket inside the device)
Pin-Number
1
2
3
4
Voltage tolerance
•Input voltage: 24 V DC ± 20%.
Current consumption
The current consumption of this device depends on the equipment version
(e.g. if a heater or WLAN, etc. is installed.)
•
Switch-on current: 7A (1ms)
•
Standby current consumption: 0.25mA
•
Regular operation: 1.3A without heater
(without any additional load on the USB ports and without delivering the +5V supply for the scanner)
Note:
The power supply can be protected with a slow-blow fuse of up to 4A.
Note:
The typical power consumption of this device is indicated in the "Technical
details" chapter.
© ads-tec GmbH • Heinrich-Hertz-Str.1• 72622 Nürtingen
IRQ
Adress
4
3F8h
3
2F8h
Signal-Name
PE
0V DC
Ignition contact
24V DC
22
Advertisement
Table of Contents
