Table of Contents
Advertisement
VMT6008
LEGIC
1) To test the RFID function, select a suitable editor (Notepad, Word) and hold the
RFID tag to the RFID reader. This information will be issued.
Note:
The output data can b pre customized in consultation with ads-tec.
5.7 COMInput-Configuration
The Application COMInput converts the data received over a serial interface, in key sequences and
feeds it then place in the Windows operating system. Thereby it is possible that the data of an RFID
reader or a bar code scanner arrive automatically without the active application.
Abb. 12:
The functionality of the application can be integrated via the Configuration Center surface at any time on
or off. The serial-to-use interface can be selected from the list of existing interfaces for activation of the
service.
Note:
Baudrate: 9600/ Databits: 8/ Stopbits: 1/ Parity: None/ FlowControl: None
Note:
If the functionality of the RFID reader has been tested, the corresponding
port has to be disabled and then enabled again, otherwise it may cause a
malfunction.
Pos : 25 /D atentec hni k/Schnitts tell en/Sc hnitts tell eneinstellung/Sc hni ttstelleneins tell ung für VMT-Serie / PLC 500 @ 0\mod_1158916296612_6.doc @ 517 @
© ads-tec GmbH • Heinrich-Hertz-Str.1• 72622 Nürtingen
21
Advertisement
Table of Contents
