If the case is connected with earth potential at the provided PE contact (e.g. by
connecting the PE contact with the device plug), the electrical insulation is no
longer given. This also applies if the device is installed by using a metal retainer
clip.
If you want to have the device electrically insulated from the power supply,
you have to use a method of installation that ensures appropriate insulation.
Pos : 18 /D atentec hni k/Inbetri ebnahme/R eihenfolg e der Inbetriebnahme/R ei henfolge der Inbetriebnahme für VMT 60xx- Seri e @ 1\mod_1222073159179_6.doc @ 4100 @
4.2 Order of Steps during Commissioning
Removing the Lid from the Service Slot
Loosen the undetachable screws on the service slot cover by using a Torx Tx10 wrench and
subsequently remove the service slot cover from the device.
Abb. 3:
Connecting The Cables
Please connect all required cables. Use grommets in this case, in order to install the cables correctly