Table of Contents
Advertisement
VMT6008
5.6 RFID-Configuration
The equipment is pre-configured to test the RFID functionality without configuration.
Note:
Check the functionality of your RFID reader through the following steps
before starting the commissioning of a software to exclude any transport
damage or other error sources.
Depending on the hardware configuration a MIFARE or LEGIC RFID reader is installed.
MIFARE
1) To test the RFID function, select the application "ads-tec RFID sample application" on the pre-
installed Configuration Center.
Ads-tec RFID-Reader Tool
The configuration of the application starts automatically, by launching the application which searches on
all COM ports to the RFID reader.
Abb. 9:
If an RFID reader is detected,it is interrogated cyclically whether a serial number (CSN) was read. It
generates a transponder serial number which is output directly to the surface.
© ads-tec GmbH • Heinrich-Hertz-Str.1• 72622 Nürtingen
19
Advertisement
Table of Contents
