Connect To A Network For Out-Of-Band Management; Connect A Management Console; Connect The Line Card Cables - Juniper MX2010 Manual

Connect to a Network for Out-of-Band Management

1. Turn off the power to the management device.
2. Plug one end of an RJ-45 Ethernet cable into the ETHERNET port on the CB-RE.
3. Plug the other end of the cable into the network device.

Connect a Management Console

1. Turn off the power to the management device.
2. Plug one end of an RJ-45 Ethernet cable into the CONSOLE or AUX port on the CB-RE.
3. Plug the female DB-9 adapter end of the cable into the device's serial port.
NOTE: We no longer include a DB-9 to RJ-45 cable or a DB-9 to RJ-45 adapter with a CAT5E
copper cable as part of the device package. If you require a console cable, you can order it
separately with the part number JNP-CBL-RJ45-DB9 (DB-9 to RJ-45 adapter with a CAT5E
copper cable).

Connect the Line Card Cables

1. Have ready a length of the type of cable used by the MPCs or MICs. For cable specifications, see the
MX Series Interface Module Reference
2. If the cable connector port is covered by a rubber safety plug, remove the plug.
LASER WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cable. Fiber-optic transceivers and fiber-optic cable connected to a
transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when inserting or
removing cable. The safety cap keeps the port clean and prevents accidental exposure
to laser light.
.
58