Figure 13: MX204 Front Panel Ports, LEDs, and Button
1
Rate-selectable ports
—
2
Management (MGMT) port
—
BITS port with LEDs
3
—
4
USB port
—
5
1PPS and 10MHz GPS input and output
—
ports
6
ONLINE LED
—
SSD1 LED
7
—
8
OFFLINE button
—
Connect the Router to a Network for Out-of-Band Management
To connect the router to a network for out-of-band management, connect an Ethernet cable with RJ-45
connectors to the MGMT port on the router. To connect to the MGMT port on the router faceplate:
NOTE: Use shielded CAT5e cable for the CON and MGMT ports on the router.
1. Turn off power to the management device.
2. Plug one end of the Ethernet cable
port on the router.
3. Plug the other end of the cable into the network device.
9
RESET button
—
10
SSD0 LED
—
Alarm (ALM) LED
11
—
12
OK/FAIL LED
—
13
Time of day (ToD) port with LEDs
—
14
Console (CON) port
—
10-Gigabit Ethernet SFP+ ports
15
—
16
PTP grandmaster clock (GM/PTP) port
—
(Figure 14 on page 14
shows the connector) into the MGMT
13