7700 MultiFrame Manual
7700S2IP-RCL QMC-2 To RCL Translator
•
A secondary RCL router controller with a system controller installed in slot 1. The system
controller has IP address 192.168.18.40. It controls the secondary RCL router. The secondary
RCL router has destination names Out1S, Out3S, Out5S, Out7S, and Out9S and source names
In1S, In3S, In5S, In7S, In9S, In11S, In13S, In15S within area name lala.
•
RCL router destinations Out1, Out3, Out5, Out7, and Out9 are connected to QMC master
control switcher inputs Program, Preset, Keyer 1 Fill, Keyer 1 Key, DVE Background
respectively.
•
An NTP server with IP address 192.168.18.37. The time provided by the NTP server is used by
the 7700S2IP-RCL when adding entries to its event log.
•
VistaLINK PRO with IP address 192.168.18.38. VLPro will be used to configure the 7700S2IP-
RCL. VLPro will receive SNMP traps from the 7700S2IP-RCL.
•
7700S2IP-RCL with IP address 192.168.18.54.
The 7700S2IP-RCL communicates:
•
with VLPro using SNMP
•
with the RCL system controllers via the RCL protocol over a TCP link
•
with the QMC master control switcher using the Quartz Remote Control Protocol over a serial
link
Conceptually, this is equivalent to:
Page-4
Figure 3-2: Example Setup
Revision 2.0