3.7.
STEP 6: CONFIGURE NTP SERVER IP ADDRESS (OPTIONAL)
The 7700S2IP-RCL maintains an event log. It is located on the General tab as shown in Figure 3-12.
Each entry in the event log has a timestamp. If the 7700S2IP-RCL is not communicating with an NTP
server, it will use the system up time in relation to January 1, 2008 for its event log timestamps. If the
7700S2IP-RCL is communicating with an NTP server, it will retrieve the UTC time from the server,
calculate the local time using the Local Offset settings, and use the local time for its event log
timestamps. To set the IP address of the NTP server:
1. From the VLPro configuration view, click the General tab.
2. Enter the IP address of the NTP server. For our example, this corresponds to 192.168.18.37.
3. Click the icon to the right of Apply.
4. Click the icon to the right of Refresh.
Figure 3-12: Specifying NTP Server
Revision 2.0
7700 MultiFrame Manual
7700S2IP-RCL QMC-2 To RCL Translator
Page-13