7700 MultiFrame Manual
7700S2IP-RCL QMC-2 To RCL Translator
2.
CARD EDGE CONTROLS
2.1.
DETERMINING CURRENT IP ADDRESS SETTINGS
To read the current IP address during normal operation, press the front switch DOWN. The IP address
can be read on the four-character alphanumeric display.
2.2.
RESTORING FACTORY DEFAULTS
To restore all settings to factory defaults, apply power to the card while holding the toggle switch UP
until the green LED is illuminated.
2.3.
CARD EDGE LEDS
LED 22 is illuminated when Ethernet activity is detected.
All other card edge LEDs are for factory use only.
Page-2
Figure 2-1: Card Edge
Revision 2.0