Table of Contents
Advertisement
3.8.
STEP 7: CONFIGURE CONTROLLER INTERFACE PARAMETERS
1. From the VLPro configuration view, click the Controller Interface tab.
2. Enter the area name of the primary controller. As per our example, the area name of the
primary controller is area. The area name is case sensitive.
3. Enter the area name of the secondary controller. As per our example, the area name of the
secondary controller is lala. The area name is case sensitive.
4. Optionally, enter the name of the video level used by the primary controller. The level name is
case sensitive. If no level is specified then the 7700S2IP-RCL will indicate all levels when
issuing the crosspoint switch request.
Figure 3-14: Controller Interface Parameters
Revision 2.0
7700 MultiFrame Manual
7700S2IP-RCL QMC-2 To RCL Translator
Page-15
Advertisement
Table of Contents
