evertz 7700 Manual page 14

7700 MultiFrame Manual
7700S2IP-RCL QMC-2 To RCL Translator
1. From the Main Menu select Network Configuration.
2. Select Set IP Address then enter the IP address, 192.168.18.54, of the 770S2IP-RCL.
3. Select Set Netmask then enter the subnet mask, 255.255.255.0, of the 7700S2IP-RCL.
4. Select Set Gateway to set the gateway IP address if the 7700S2IP-RCL resides on an IP
network which differs from that of the controller(s), NTP server, or VLPro. The gateway can be
left as 0.0.0.0 if the 7700S2IP-RCL and the controller(s), NTP server and VLPro reside on the
same IP network.
5. For a manually entered network configuration, ensure DHCP enabled is set to False. A setting
of True means the 7700S2IP-RCL will, upon boot, try to fetch network settings from a DHCP
server. The Use DHCP entry permits changes to this parameter.
6. Once the network settings are configured, select Save and Exit before exiting the Network
Configuration to save the settings, otherwise select Exit.
7. Reboot the 7700S2IP-RCL. This can be done by selecting Engineering/Debug from the Main
Menu, then Reboot, then y.
8. Ensure the VLPro machine can ping the 7700S2IP-RCL.
The 7700S2IP-RCL must be rebooted for any network setting changes to take
effect.
Page-10
Revision 2.0