Table of Contents
Advertisement
6.1.2.
Genlock Source
The VLPRO interface for the Genlock Source control appears as follows:
The control values for the Genlock Source control have the following meanings
None
When None is selected, the module will lock to incoming video.
When External is selected, the module will lock to the external reference signal applied to the
External
module's rear panel (DA4A/Genlock BNC). Reference bi-level black should only be used.
When Frame 1 is selected, the module will lock to the external reference applied to the 7800
Frame 1
frame REF 1 input.
When Frame 2 is selected, the module will lock to the external reference applied to the 7800
Frame 2
frame REF 2 input.
6.1.3.
CONFIGURING HIGH LEVEL CARD CONTROLS – MISC FAULTS
The VLPRO interface for configuring the MISC FAULTS control tab appears as follows:
To enable a specific Fault trap, click the small box beside the relevant fault and ensure that a check mark
appears in the box. To disable a specific Fault trap, click the small box beside the relevant fault and
ensure that a check mark does not appear in the box.
7812DCDA2Q-HD (-AA, –AES4) Dual Path HDTV Down-converter
Figure 6-3: Genlock Source Control
Figure 6-4: Misc Faults Tab
Revision 1.0
7800 MultiFrame Manual
Page 19
Advertisement
Table of Contents
