7800 MultiFrame Manual
7880DEC-MP2HD-2 Dual HD MPEG-2 Decoder
3.
CARD CONFIGURATION
Right click the IP address of the 7880DEC-MP2HD-2 and select "View Configuration". The
configuration page will open; it is from these configuration tabs that the 7880DEC-MP2HD-2 can be
configured. Refer to the relevant section of this manual for an explanation of the features and functions.
3.1.
INPUT SELECT
The input selection tab is used to select the input in use. Both inputs are bypass protected, thus in the
event of the card failing, being removed or the power being cut off, the loop-through for the ASI will
continue. The decoded output will no longer be available.
NOTE: If the card is removed from the chassis, the ASI loop through will continue
but the decoded output will no longer be available.
•
Input Select: The decoder card has two ASI inputs. Select here the input you require.
NOTE: The decoder has two ASI inputs; the card is a single decoder and is only
able to decode one program from either of the two inputs.
•
Input Mode Select:
7880DEC-MP2HD-2 - 10
Figure 3-1 VistaLINK
®
Revision 1.0
PRO – Input Select