Table of Contents
Advertisement
Loading Paper into the Interposer
• Do not place anything on top of or leave documents on the sensor. This may lead to the paper size
not being correctly scanned or paper jams.
• When using the Z-fold function, the paper in the interposer must be of the same size as the prints
after they have been folded. If the paper in the interposer is larger than the Z-folded sheets, a
misfeed might occur.
1.
Load paper orderly.
Do not stack paper over the limit mark.
2.
Adjust the side fences to the paper size.
• Load paper with its printed side up (the front side).
• Load paper in the interposer in the same orientation as paper in the paper tray.
• The staple position or punch hole position will be on the left side of the paper, when you are facing
the machine.
• To load the paper in the interposer, align the orientation of originals in the ADF as shown below.
CVA030
CVA031
Loading Paper into the Interposer
117
Advertisement
Table of Contents
