Loading Paper Into The Interposer - Ricoh pro c900s Operating Instructions Manual

4. Press the elevator switch on the multi bypass tray.
The green lamp of the elevator switch flashes when the tray is moving and remains lit when the tray
is still.
If you want to add new paper or remove jammed paper, first press the elevator switch to lower the
tray.
• When paper is loaded which cannot be detected automatically, the user must set the paper size on
the control panel.
• p.73 "Changing to a Size That Is Not Automatically Detected"

Loading Paper into the Interposer

This section describes how to load paper into the interposer.
• Load paper on the side already printed (the front side). If you are using the Booklet Finisher (Saddle
Stitch), load sheets print side down.
• Load paper in the interposer in the same orientation as paper in the paper tray.
• The staple or punching location will be on the left side of the paper, when you are facing the machine.
• Do not place anything on top of or leave documents on the sensor. This may lead to the paper size
not being correctly detected or paper jams.
• When using the Z-fold function, the paper in the interposer must be of the same size as the prints after
they have been Z-folded. If the paper in the interposer is larger than the Z-folded sheets, a misfeed
might occur.
• Each tray can hold up to 200 sheets of paper. Do not stack paper over the limit mark.
• Do not use paper that has already been printed onto by this machine.
BJU044S
Loading Paper
4
61