Ingersoll-Rand HP600A-WCU Operating, Maintenance & Parts Manual page 38

."~.'.""I"iii .
•
c
Normally, regulation requires no adjusting, but if proper adjust-
ment is lost, proceed as follows:
Before Starting Unit
1. At engine governor, (EG), check the position of thro~le
arm (A) on governor shaft (8). This is done by loosenrng
nut
(C)
that clamps
the
throttle arm (A) to the shaft.(8) .
.... ," - -., •• "C;.'[":. • .•
,~!:::: ,..
'.>~:': .:;:
.ar as possible.
:-. i..
I. : • . • , .~. " ."
_J. '. - . . •
C
Rotate throttle ami ~: .,1'
il :S
vertical.
Tighten nut ( ).
2, Adjust jam nut (0) on throttle spri~g rod ()E)to fully relieve
tension on two compression springs (F .
continued -
. Book 35386598, S/92
I