Table of Contents
Advertisement
D-Sub 9-pin (male)
Outside view
(9)
(6)
(5)
(1)
Note
f A cable with pin (4) connected to each other such as full wired straight cable is required as the cable when using the contrast
synchronization function or the shutter synchronization function. Pin.(4) is used for data communication of contrast synchronization function/
shutter synchronization.
Communication conditions (Factory default)
Signal level
Sync. method
Baud rate
Parity
Character length
Stop bit
X parameter
S parameter
Basic format
Transmission from the computer starts with STX, then the ID, command, parameter, and ETX are sent in this
order. Add parameters according to the details of control.
ZZ, 01 to 64 and 0A to 0Z
(2 bytes)
Start (1 byte)
Chapter 7 Appendix — Technical information
Pin No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
RS-232C-compliant
Asynchronous
9 600 bps
None
8 bits
1 bit
None
None
ID designate
3 command characters (3 bytes)
Semi-colon (1 byte)
2 ID characters (2 bytes)
Signal name
―
NC
RXD
Received data
TXD
Transmitted data
―
NC
GND
Earth
―
NC
RTS
Connected internally
CTS
―
NC
Parameter (undefined length)
Colon (1 byte)
Details
End (1 byte)
ENGLISH - 285
Advertisement
Table of Contents
