Sinclair SDV 6 User & Installation Manual page 59

8 ENGINEERING SETTINGS
8.1 Parameter settings of the wired controller
● Parameters can be set in the power-on or power-off state.
● Hold " " and "
interface.
● After entering the parameter setting interface, Press "
switch the parameter. Set parameters according to the Table of
Parameter Settings. Press "
Then press "
save changes.
● Press the " back " button to return to the previous page until exiting the
parameter setting or exiting the parameter setting after 60s without any
operation.
● When it is in the parameter settings page, the wired controller does not
respond to any remote control signal.
" for 3 seconds to enter the parameter setting
" to enter the parameter setting interface.
" and " " to change parameter value and press "
56
" and " " to
" to