Table of Contents
Advertisement
Installing the Server into a Telco Rack
Two optional L-shaped brackets are needed to install the server to a telco (open type) rack.
Installing the Server into a Telco Rack
1. Determine how far follow the server will extend out the front of the rack. Larger chassis
should be positioned to balance the weight between front and back.
2. If a bezel is included on your server, remove it.
3. Attach the two front brackets to each side of the chassis, then the two rear brackets
positioned with just enough space to accommodate the width of the telco rack.
4. Finish by sliding the chassis into the rack and tightening the brackets to the rack.
Figure 2-6. Installing the Chassis into a Telco Rack
Note: Figure is for illustrative purposes only. Always install servers to the bottom of a rack first.
Chapter 2: Server Installation
25
Advertisement
Table of Contents
