Supermicro SuperServer SYS-1029UX-LL1-S16 User Manual page 56

SuperServer SYS-1029UX-LL1-S16/LL2-S16/LL3-S16 User's Manual
VGA Enable/Disable
JPG1 allows you to enable or disable the VGA port using the onboard graphics controller.
The default setting is Enabled.
Manufacturing Mode
Close JPME2 to bypass SPI flash security and force the system to use the Manufacturing
Mode, which will allow you to flash the system firmware from a host server to modify system
settings. See the table below for jumper settings.
Management Engine (ME) Recovery
Use jumper JPME1 to select ME Firmware Recovery mode, which will limit resource
allocation for essential system operation only in order to maintain normal power operation
and management. In the single operation mode, online upgrade will be available via Recovery
mode. See the table below for jumper settings.
VGA Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
Manufacturing Mode Select
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal (Default)
Pins 2-3 Manufacturing Mode
Manufacturer Mode
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal
Pins 2-3 ME Recovery
56