Installing The Server Into A Two Post (Telco) Rack - Supermicro SuperServer AS -1015A-MT User Manual

Installing the Server into a Two Post (Telco) Rack

Optional brackets (p/n MCP-290-00016-0N) are needed to install the server to a two post
(telco type) rack. Use the two L-shaped brackets on either side of the chassis (four total).
1. First, determine how far follow the server will extend out the front of the rack. Larger
chassis should be positioned to balance the weight between front and back. If a bezel is
included on your server, remove it.
2. Attach the two front brackets to each side of the chassis, then the two rear brackets
positioned with just enough space to accommodate the width of the telco rack.
3. Finish by sliding the chassis into the rack and tightening the brackets to the rack.
Figure 2-5. Installing the Server into a Telco Rack
Note: The figure above is for illustrative purposes only. Always install servers at the bottom
of the rack first.
23
Chapter 2: Installation