Table of Contents
Advertisement
2.2.2 Rack Mounting
To install the Managed Switch in a 19-inch standard rack, please follow the instructions described below.
Step 1:
Place the Managed Switch on a hard flat surface, with the front panel positioned towards the front side.
Step 2:
Attach the rack-mount bracket to each side of the Managed Switch with supplied screws attached to the package.
Figure 2-1-5
shows how to attach brackets to one side of the Managed Switch.
You must use the screws supplied with the mounting brackets. Damage caused to the parts by
using incorrect screws would invalidate the warranty.
Step 3:
Secure the brackets tightly.
Step 4:
Follow the same steps to attach the second bracket to the opposite side.
Step 5:
After the brackets are attached to the Managed Switch, use suitable screws to securely attach the brackets to the
as shown in
Figure
2-1-6.
Step 6:
Proceed with Steps 4 and 5 of session 2.2.1 Desktop Installation to connect the network cabling and supply power to the
Managed Switch.
User's Manual of GS-4210-8UP2S/GS-4210-16UP4C/GS-4210-24UP4C
Figure 2-1-5 Attach Brackets to the Managed Switch.
Figure 2-1-6 Mounting Managed Switch in a Rack
40
rack,
Advertisement
Table of Contents
