Planet GS-4210-8UP2S User Manual page 329

 Extended Mode
 Priority
 PD Class
 Current Used [mA]
 Power Used [W]
 Power Allocation [W]
Buttons
: Click to apply changes.
User's Manual of GS-4210-8UP2S/GS-4210-16UP4C/GS-4210-24UP4C
mode is used to support legacy devices.

UPOE: Set inline mode to PoH (Power over HD-BASE-T) 4-pair PoE+
PSE Pins 1-2 (pair #2 in both T568A and T568B) form one side of the
DC supply and pins 3-6 (pair #3 in both T568A and T568B) provide the
return.
Pins 4-5 (pair #1 in both T568A and T568B) form one side of the DC
supply and pins 7-8 (pair #4 in both T568A and T568B) provide the
return
Maximum power is 72-60.0 watts.
(GS-4210-8UP2S only)

Force: The force power function will directly deliver power over UTP
cable. Please be careful when using force power function and make
sure the remote device is PoE powered device (PD).
(GS-4210-16UP4C/GS-4210-24UP4C only)
Provide to disable or enable PoE extended mode.
The Priority represents PoE ports priority. There are three levels of power priority
named Low, High and Critical.
The priority is used in case the total power consumption is over the total power
budget. In this case the port with the lowest priority will be turned off, and offer
power for the port of higher priority.
Displays the class of the PD attached to the port, as established by the
classification process. Class 0 is the default for PDs. The PD is powered based
on PoE Class level if the system is working in Classification mode.
The Power Used shows how much current the PD currently is using.
The Power Used shows how much power the PD currently is using.
It can limit the port PoE supply watts. Per port maximum value must be 95
watts. Total port values must be less than the Power Reservation value. Once
power overload is detected, the port will auto shut down and keep in detection
mode until PD's power consumption is lower than the power limit value.
329