Rack Mounting - Planet GSD-802S User Manual

2.2.2 Rack Mounting

To install the Gigabit Ethernet Switch in a 19-inch standard rack, please follows the instructions described below.
Step1: Place the Gigabit Ethernet Switch on a hard flat surface, with the front panel positioned towards the front side.
Step2: Attach the rack-mount bracket to each side of the Gigabit Ethernet Switch, with supplied screws attached to the
package. Figure 2-7
Caution:
You must use the screws supplied with the mounting brackets. Damage caused to the parts by using incorrect
screws would invalidate the warranty.
Step3: Secure the brackets tightly.
Step4: Follow the same steps to attach the second bracket to the opposite side.
Step5: After the brackets are attached to the Gigabit Ethernet Switch, use suitable screws to securely attach the brackets
to the rack, as shown in
Step6: Proceeds with the steps 4 and steps 5 of session 2.2.1 Desktop Installation to connect the network cabling and
supply power to the Gigabit Ethernet Switch.
shows how to attach brackets to one side of the Gigabit Ethernet Switch.
Figure 2-7 Attach brackets to the Gigabit Ethernet Switch.
Figure 2-8.
Figure 2-8 Mounting the Gigabit Ethernet Switch in a Rack
User's Manual of GSD-802S / GSD-802PS