Installing The Poe Injector Hub; Desktop Installation; Rack Mounting - Planet HPOE-1200G User Manual

The PoE Injector Hub is a power-required device, meaning PoE Injector Hub will not work till it is
powered. If your networks should be active all the time, please consider using UPS (Uninterrupted
Power Supply) for your device. It will prevent you from network data loss or network downtime.
In some area, installing a surge suppression device may also help to protect your device from being
damaged by unregulated surge or current to the PoE Injector Hub or the power adapter.

2.2 Installing the PoE Injector Hub

This section describes how to install your PoE Injector Hub and make connections to the PoE Injector Hub. Please read the
following topics and perform the procedures in the order being presented. PLANET PoE Injector Hub does not need
software configuration.

2.2.1 Desktop Installation

To install a PoE Injector Hub on a desktop or shelf, simply complete the following steps:
Step 1: Attach the rubber feet to the recessed areas on the bottom of the PoE Injector Hub.
Step 2: Place the PoE Injector Hub on a desktop or shelf near an AC power source.
Step 3: Keep enough ventilation space between the PoE Injector Hub and the surrounding objects.
When choosing a location, please keep in mind the environmental restrictions discussed in Chapter
1, Section 5, under Specifications.
Step 4: Connect your PoE Injector Hub to network 802.3at / 802.3af powered devices (PD) and Switch.
A. Connect one end of a standard network cable to the upper stack 10/100/1000 RJ-45 ports on the front of the PoE
Injector Hub.
B. Connect the other end of the cable to the 802.3at / 802.3af powered devices (PD) such as IP phone, wireless
access point, IP camera, splitter, or switch etc.
C. Connect one end of a standard network cable to the relative lower stack 10/100/1000 RJ-45 port on the front of
the PoE Injector Hub.
D. Connect the other end of the cable to the port of Switch.
Connecting to the PoE Injector Hub requires UTP Category 5e/6 network cabling with RJ-45 tips. For
more information, please see the Cabling Specification in Appendix A.
Step 5: Supply Power to the PoE Injector Hub.
A. Connect one end of the power cable to the PoE Injector Hub.
B. Connect the power plug of the power cable to a standard wall outlet.
When the PoE Injector Hub receives power, the Power LED should remain solid Green.

2.2.2 Rack Mounting

To install the PoE Injector Hub in a 19-inch standard rack, follow the instructions described below.
Step 1: Place your PoE Injector Hub on a hard flat surface, with the front panel positioned towards your front side.
User's Manual of HPOE-1200G / HPOE 2400G
14