Space-Ray ADU25 Installation And Operation Instruction Manual page 37

Fig. 22g
10. Place the upper reflector panels over each of the reflector spacer brackets. Repeat the same reflector
positions and overlap dimensions as specified in table 16, see step 9 above. To align reflectors precisely to
the ends of the lower reflector, hold the end cap in place against the lower reflector slide the upper reflector
to rest against it. See figure 22h below.
Fig. 22h
11. Secure the upper reflector panels to the reflector spacer brackets as shown in figure 21i below:
III. Screw through the reflector with the #10 self drilling screws into the reflector spacer bracket.
IV. Repeat this at each hanger bracket specified in figure 22i.
Fig. 22i
-36-
Form #44201100
Oct 2019