Space-Ray ADU25 Installation And Operation Instruction Manual page 32

13. Secure the upper reflector panels to the reflector spacer brackets as shown in figure 21n below:
I. Screw through the reflector with the #10 self drilling screws into the reflector spacer bracket.
II. Repeat this at each hanger bracket specified in figure 21n.
Fig. 21n
14. Place side panels over the sides of both reflector panels between each tube support/hanger bracket and at
the ends of the heater. Secure these in place using the side panel holder brackets and two #10 x 1/2" sheet
metal screws supplied in fastenings kit. See Figure. 21o below:
Fig. 21o
Form #4420110
Oct 2019 -31-