Space-Ray ADU25 Installation And Operation Instruction Manual page 36

Table 16.
Model A
ADL25 76
ADL30/35 214
ADL40/45 214
All Dimensions in mm.
Fig. 22e
8. With the lower reflector panels in place secure the reflectors to the hanger brackets on both sides of the
reflector as shown in figure 21f.
IV. From the underside of the hanger bracket drive in the sheet metal screw until the tip is just through the
reflector panel.
V. Position the Reflector Locking Clamp over the screw and continue to drive the screw until the reflector is
secured in place.
VI. Repeat this at each hanger bracket specified in figure 22f. Note: the reflector is NOT clamped at the second
and second to last hanger bracket on every model.
Fig. 22f
9. Attach the reflector spacer brackets at each tube support/hanger bracket. using the #10-24 machine
screws supplied in fastening kit. See figure 22g below:
Form #4420110
Oct 2019
R1 O1 R2
3035 178 3035
3035 127 3035
3035 127 3035
O2 R3 O3
178 3035 368
127 3035 195
127 3035 127
-35-
R4 O4 R5
610 N/A N/A
610 N/A N/A
3035 55 610