Casio 3554 Operation Manual page 73

Alert Screen Switching
A training alert screen appears when a
specified target value is reached during
activity measurement.
Example:
The watch returns to the running
●
measurement screen if you press (C) or if
you do not perform any operation for about
nine seconds.
Configuring Distance
Measurement Settings
You can select measurement of either linear
distance (straight-line distance) or surface
distance (actual distance).
Surface distance measurements are
calculated by taking horizontal travel as well
as vertical movement into consideration.
1.
Display the current time screen.
Watch Mode
l
2.
Press (C).
This enters the Activity Mode.
Example:
3.
Use (A) and (D) to select an activity.
4.
Press (C).
This displays the GPS signal receive start
screen.
Watch Operation Guide 3554
5.
Press (A) or (D).
This displays the measurement operation
ready screen.
6.
Hold down (A) for at least two seconds.
This displays the activity measurement
setting screen.
Pointer
7.
Use (A) and (D) to move the pointer to
[GPS TRACKING].
8.
Press (C).
9.
Use (A) and (D) to move the pointer to [3D
DISTANCE].
10.
Press (C).
11.
Use (A) and (D) to select a setting.
[ON]
[OFF]
12.
Press (C) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the GPS setting screen re-
appears.
13.
Press (E) to exit the setting screen.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
You can also use the CASIO
●
WATCHES phone app to change the
distance measurement type.
Surface distance measurement
Linear distance measurement
Configuring Interval Timer
Settings
To configure interval timer settings with
●
the CASIO WATCHES phone app
You can use the CASIO WATCHES phone
app to configure an interval timer that
combines multiple types of timers.
For information about interval timers, see
●
the information below.
Overview
l
Check the connection
Make sure the symbol is shown on the
e
●
watch display when you perform the
procedure below. If is not displayed,
e
refer to the information at the link below.
Connecting with a Phone Paired
l
With the Watch
1. Y
Tap the "CASIO WATCHES" icon.
2. Y
Tap the "My Watch" tab.
3. Y
Select "GPR-H1000" and tap it.
4. Y
Select the setting you want to change
and then perform the operation shown on
the screen.
73