Casio 3554 Operation Manual page 42

5.
Use (A) and (D) to move the pointer to
[FIGURE 8].
6.
Press (C).
This displays the figure 8 calibration
screen.
When the screen shown above appears,
move your arm in a figure 8 pattern as
shown in the illustrations below.
Allow your wrist to twist.
●
Keep your arm as far as possible from
●
your body as you move it.
After calibration is successful, a check
●
mark appears for a few seconds, and
then the setting screen re-appears.
Note
The message [FAILED RETRY?]
●
appears on the display if calibration
fails.
Press (A) or (D) to select [YES] (Re-
calibrate) or [NO] (Stop calibration),
and then press (C).
To return to the direction measurement
●
setting screen during the above
procedure, press (E).
Watch Operation Guide 3554
Setting Up for True North Readings
(Magnetic Declination Calibration)
If you want the watch to indicate true north
instead of magnetic north, you need to specify
your current location's magnetic declination
direction (east or west) and declination angle.
Magnetic North and True North
l
The magnetic declination angle value can
●
be set in 1° (degree) units only. Use a value
that is closest to the angle you want to set.
Example: For an angle of 7.4°, set 7°.
Example: For an angle of 7°40' (7 degrees,
40 minutes), set 8°.
Note
Magnetic declination angles (east or
●
west) and angle degree values for
specific locations can be found on
geographic maps, mountain climbing
maps, and other maps that include
contour lines.
1.
Display the current time screen.
Watch Mode
l
2.
Use (A) and (D) to select [COMPASS].
3.
Press (C).
4.
Hold down (A) for at least two seconds.
This displays the direction measurement
setting screen.
Pointer
5.
Use (A) and (D) to move the pointer to
[MAGNETIC DECLINATION].
6.
Press (C).
7.
Press (A) (West) or (D) (East) to change
the magnetic declination direction and
angle.
Setting range: 90° west to 90° east
[0° (OFF)] Magnetic north
Magnetic north east of true
[E]
north (East declination)
Magnetic north west of true
[W]
north (West declination)
Magnetic declination direction
Magnetic declination angle
To stop the setting operation, press (E)
●
and advance to step 9.
8.
Press (C) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the bearing measurement
setting screen re-appears.
9.
Hold down (E) for at least one second to
return to the current time screen.
42