Casio 3554 Operation Manual page 71

Changing the GPS Receive
Interval
Use the procedure below to specify the
interval for receiving GPS signals and to
acquire location information during activity
measurement.
1.
Display the current time screen.
Watch Mode
l
2.
Press (C).
This enters the Activity Mode.
Example:
3.
Use (A) and (D) to select an activity.
4.
Press (C).
This displays the GPS signal receive start
screen.
5.
Press (A) or (D).
This displays the measurement operation
ready screen.
6.
Hold down (A) for at least two seconds.
This displays the activity measurement
setting screen.
Pointer
7.
Use (A) and (D) to move the pointer to
[GPS TRACKING].
8.
Press (C).
9.
Use (A) and (D) to move the pointer to
[GPS].
10.
Press (C).
Watch Operation Guide 3554
11.
Use (A) and (D) to select a GPS receive
interval.
[HIGH]
[NORMAL]
[LONG]
[OFF]
12.
Press (C) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the GPS setting screen re-
appears.
13.
Press (E) twice to exit the setting screen.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
You can also change the GPS receive
●
interval using the CASIO WATCHES
phone app.
With BIKING or OPEN WATER
●
SWIMMING, distance traveled is not
displayed in the measurement results
when the GPS reception interval is
[LONG] or [OFF].
Receive interval: Every
second
Positioning accuracy: High
Receive interval: Every
second
Positioning accuracy: Lower
than [HIGH]
Receive interval: Every
minute
GPS not used.
Configuring Training Alert
Settings
You can use the CASIO WATCHES phone
app to specify target alert intervals to inform
you of your calories burned, elapsed time,
distance traveled, and altitude climbed during
training. Every time an alert target value is
reached during activity measurement, a
sound or vibration operation is performed, and
an alert screen appears to notify you.
You can use a single watch operation to toggle
all the alerts you configured with the CASIO
WATCHES phone app between on and off.
To specify training alert target values
●
with the CASIO WATCHES phone app
Important!
Note that you cannot specify alert
●
target values using watch operations.
Use the CASIO WATCHES phone app
to configure settings.
Check the connection
Make sure the symbol is shown on the
e
●
watch display when you perform the
procedure below. If is not displayed,
e
refer to the information at the link below.
Connecting with a Phone Paired
l
With the Watch
1. Y
Tap the "CASIO WATCHES" icon.
2. Y
Tap the "My Watch" tab.
3. Y
Select "GPR-H1000" and tap it.
4. Y
Select the setting you want to change
and then perform the operation shown on
the screen.
71