Casio 3554 Operation Manual page 69

To configure auto lap settings with the
●
watch
1.
Display the current time screen.
Watch Mode
l
2.
Press (C).
This enters the Activity Mode.
Example:
3.
Use (A) and (D) to select an activity.
4.
Press (C).
For activities that can be measured
●
without receiving GPS signals, this
operation returns to the measurement
operation ready screen. In this case,
advance to step 6.
If you selected an activity that receives
●
GPS signals for measurement, this
operation starts the GPS signal receive
operation.
5.
If you selected an activity that receives
GPS signals for measurement, press (A)
or (D).
This displays the measurement operation
ready screen.
6.
Hold down (A) for at least two seconds.
This displays the activity measurement
setting screen.
Pointer
7.
Use (A) and (D) to move the pointer to
[AUTO LAP].
8.
Press (C).
9.
Use (A) and (D) to select [ON].
To disable auto lap measurement,
●
select [OFF].
The currently selected setting is
●
indicated by a check mark (
left.
Watch Operation Guide 3554
10.
Press (C).
This causes a cursor to appear, which you
can use to set the auto lap measurement
distance.
11.
Use (A) and (D) to specify the integer part
of the distance value.
12.
Press (C).
This moves the cursor to the decimal part
of the distance value.
13.
Use (A) and (D) to specify the decimal part
of the distance value.
14.
Press (C) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the activity measurement setting
screen re-appears.
15.
Press (E) to exit the setting screen.
Note
If GPS is being used for Auto Lap
●
measurement, the Auto Lap
measurement timing may be
somewhat different from the distance
setting.
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
) to the
Setting the Swimming Pool
Length
Specifying a pool length helps when
measuring lap times.
1.
Display the current time screen.
Watch Mode
l
2.
Press (C).
This enters the Activity Mode.
3.
Use (A) and (D) to select [POOL
SWIMMING].
4.
Press (C).
5.
Hold down (A) for at least two seconds.
This displays the pool swimming setting
screen.
Pointer
6.
Use (A) and (D) to move the pointer to
[POOL LENGTH].
7.
Press (C).
This displays the pool length setting
screen.
Pointer
69