Casio 3554 Operation Manual page 22

To start measurement
●
1.
Press (C).
This starts activity measurement.
This displays a screen of the
●
measurement being performed for the
activity you specified with CASIO
WATCHES phone app.
Configuring Activity Measurement
l
Display Settings
Note
For activities that require GPS signal
●
reception, you can determine if GPS
measurement is possible by checking
the icon.
Not Flashing: GPS measurement is
possible
Flashing: GPS measurement is not
possible (Watch is searching for GPS
signals.)
If appears on the display after [GPS
●
READY] is displayed, it means the
GPS signal has been lost, and the
watch is searching for it.
If is flashing or if is displayed
●
while activity measurement is in
progress, tracking of the activity will not
be recorded.
If you enter the function settings before
●
starting an activity measurement
operation, GPS measurement pauses
temporarily. The watch starts
searching for GPS signals again when
you exit the settings.
When using GPS for run timing, wait
until [GPS READY] appears on the
display before you start.
Watch Operation Guide 3554
To pause or end a measurement
●
operation
1.
While an activity measurement operation
is in progress, press (C).
This pauses activity measurement and
opens the pause menu screen.
2.
Use (A) and (D) to choose what to do with
the activity data that was being measured.
[RESUME]
[SAVE]
[DISCARD]
3.
Press (C).
Choosing to save the data causes the
●
activity measurement result screen to
appear.
You can use (A) and (D) to scroll
between summary screens.
The display returns to the screen for the
selected activity after a short while or
when you press (E).
Choosing to delete the data causes the
●
screen for the selected activity to
appear.
Pause Pause menu
Resumes timing.
Saves the data and ends the
measurement.
Ends the measurement
without saving the data.
To measure lap times
●
1.
This starts activity measurement.
To start measurement
l
2.
Press (E).
Each press of (E) displays the elapsed
time of the current section (lap time) to
appear.
Number of Laps
Split time
3.
Press (C) to pause activity measurement.
To pause or end a measurement
l
operation
Note
In the case of POOL SWIMMING, lap
●
measurement cannot be performed
using the above operation.
Before Using Pool Swimming
(POOL SWIMMING)
You need to configure the settings before
using the POOL SWIMMING activity.
Specify the length of the pool to be used
●
Setting the Swimming Pool Length
l
The pool length you specify is used to
ー
calculate the distance swum each time
you perform a turn, which is interpreted
as a lap.
After you stop swimming, a lap will be
ー
obtained after about six seconds.
Specify the arm where you wear the watch
●
This is necessary to detect the number of
strokes and other data.
Creating Your Profile
l
Lap time
22