Modify Start Scanning Command; Modify Stop Scanning Command - Newland FM510 Series User Manual

Disable Trigger Commands

Modify Start Scanning Command

The Start Scanning command can consist of 1-10 characters (HEX values from 0x01 to 0xFF). In this command, the
character "?" (HEX: 0x3F) cannot be the first character. The default Start Scanning command is <SOH> T <EOT>.
Set the Start Scanning command to "*T":
1.
2.
3.
4.
5.

Modify Stop Scanning Command

The Stop Scanning command can consist of 1-10 characters (HEX values from 0x01 to 0xFF). In this command, the
character "?" (HEX: 0x3F) cannot be the first character. The default Stop Scanning command is <SOH> P <EOT>.
41
Modify Start Scanning Command
Scan the Enter Setup barcode.
Scan the Modify Start Scanning Command barcode.
Scan the numeric barcodes "2", "A", "5" and "4" from the "Digit Barcodes" section in Appendix.
Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
Scan the Exit Setup barcode.
Enter Setup
Enable Trigger Commands
** Exit Setup