Factory Defaults Table (Mongo-M_V2.St.g02.2) - Newland FM515 Series User Manual

Factory Defaults Table (MONGO-M_V2.ST.G02.2)

Parameter
System Settings
Barcode Programming
Programming Barcode Data
Scan Mode
Decode Session Timeout
Reread Timeout
Reread Timeout Reset
Good Read Delay
Read Barcode On/Off
Bad Read Message
Trigger Commands
Start Scanning Command
Stop Scanning Command
Illumination
Good Read LED
Good Read LED Duration
Security Level
Enable/Disable Switching Input
Trigger Slope
Trigger Duration
Debounce Duration
Enable/Disable Switching Output
Output High/Low Level
Output Duration
Enable Level Output
Stop Level Output
Default Interface
RS-232 Interface
Baud Rate
Parity Check
Factory Default
Disabled (Exit Setup)
Do not transmit
Level Mode
0ms
Enabled, 0ms
Off
Disabled, 500ms
On
On
"?"
Disabled
<SOH> T <EOT>
<SOH> P <EOT>
Normal
On
20ms
1
Disabled
Negative Slope
0ms
10ms
Disabled
Output High Level
400ms
Output Level After a Good Read
Stop Level Output When Another Decode
Session Starts
RS-232
9600
None
Remark
1-3,600,000ms; 0: Infinite
1-3,600,000ms
1-3,600,000ms
1-7 characters
0-60,000ms
0-250ms
0-60,000ms
140