Maintenance - Compak K3 User Manual

11.

MAINTENANCE

11.1 GENERAL WARNING
Before performing any type of maintenance
you should:
•
Always turn OFF the main power switch
to the off position (
•
If the grinder is jammed, unplug it
from the power source and contact an
authorized service technician.
In case of breakdown or malfunction, turn off
the appliance, we should never try to repair
it, it is essential to call the nearest technical
service.
NOTE: Not
warnings can compromise the
safety of the grinder as well as the
user.
11.2 GENERAL MAINTENANCE OF THE
GRIND CHAMBER
To guarantee the efficiency and correct
operation of the grinder, it is essential to follow
manufacturer instructions and ensure that all
maintenance work is carried out by qualified
staff.
Dull burrs will result in; a lower quality grind,
greater heat generation in the coffee and grinder,
increased electrical consumption, and finally it
puts additional stress on the grinder motor.
Not following the recommended
burr life
compromise the safety of the
grinder.
These operation should be done
by a qualified service technician
wearing safety gloves.
16
).
following these
guidelines can
K09652H00 | PROC-CAL/002/03 USER MANUAL | V. 29/06/2023
11.3 GRINDING GROUP MAINTENANCE
To perform grind chamber maintenance
please observe the following steps:
11.3.1 Turn off the grinder by making sure
the main power switch (
position. Disconnect the plug from the power
source. Loosen the hopper security screw
( ) using a Phillips head screw driver as
seen in (Fig. 1).
Fig. 1
11.3.2 Check that the shutter is in the closed
position before removing the hopper from
the grind regulator (
Fig. 2
) is on the OFF
) (Fig. 2).